Draper SC1 Manual de Instruções descarregar pdf (Página 78)

The next part of the install is to program the group addresses. For this you will have to check several different things:

1 Are the low voltage lines from the motors going to an ILT Tap? Are the ILT Taps connected together with Cat 5? Do you have a 12V trans

former feeding power to every 40 ILT Taps?

2 You may use a splitter to put up to 3 motors in an ILT Tap, but a motor cannot have more than 30’ of cable between it and an ILT Tap even

with a splitter.

3 If the Draper Digital Network is programmed and powered, then you may plug your computer into an ILT Tap on the network and

program.

4 The laptop will plug in as before, but the ILT Tap that it now plugs into will be on the network.

5 You will pull up the GUI that you used to get the motor address.

6 You will type in a motor address that you wish to program and hit the “GET DATA” button.

7 The motor will talk back. If you get an error, then you need to check your set-up as communication is not getting to the motor.

8 You will then change the group addresses to be as you want them and hit “Compute IP Range”, then hit the “Send Data” button. This will

program the motor with the addresses that you want.

9 You will then proceed back to step 6 for the next motor address until all motors are programmed.

Lastly, you will program smart switches and the IP interface to the switch conﬁ guration that you want. You program the IP interface and smart

switch as follows.

1 A smart switch is programmed with the same set-up as you used to get a motor address. Except, you will plug in a smart switch not a

motor, but you will plug a smart switch into the ILT Tap by connecting the Cat 5 to the switch.

2 You will pull up a GUI on your laptop for programming the switch and you will determine what addresses you want the switch to send

when buttons are pressed.

3 To program the IP interface, you will need to connect to the server. You will type in the IP address of the interface and access the settings

on the interface.

4 At the settings page, you will set up virtual buttons and what actions you want behind each button.

Programming switches, motor, and IP interface will have more details than this so please use these pages as a reference for the amount of

work done to program the system.

www.draperinc.com

(765) 987-799

Page 78 of 120

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 119 120

Sem comentários

Draper SC1 Manual de Instruções Página 78