Draper SC1 Manual de Instruções descarregar pdf (Página 64)

SUN AND WIND SENSOR V1.l and SUN SENSOR SWITCH V4 by Draper Page 9 of 9

You cannot program the Sun Sensor Switch using S+7+7 CloseALL unless you are using a splitter etc. The

CloseALL command is interpreted by the SUN AND WIND SENSOR as "'enter program mode" - and it turns on its

GREEN LED and awaits programming commands -and the Sun Sensor Switch goes into program mode, and they do

not use the same programming steps.

Sun Sensor Switch Reporting Delay:

Be aware that the LEDs on the Sun Sensor Switch may lag behind an actual change in light level or other event by as

much as 6 seconds.

This is particularly significant when demonstrating light reactions.

Debug feature, simulating an event:

The Sun Sensor Switch can be used to simulate an event to verify that everything is programmed as desired.

Press and hold the desired 'level" button on the Programming Switch, then press and hold the STOP (middle) button

for 4 seconds to simulate the event associated with that level of wind.

Press and hold the desired button on the Programming Switch, then press and hold the top button for 4 seconds to

simulate the event associated with that level at sunrise (Summer/Winter is whatever is currently selected).

Press and hold the desired button on the Programming Switch, then press and hold the bottom button for 4 seconds to

simulate the event associated with that level at sunset.

If there is no action associated with that level then nothing will happen.

Be careful to not push multiple buttons on the Programming Switch, as that may cause a configuration change!

Order dependent programming on SUN AND WIND SENSOR:

Forcing user level set must be done only after setting all events C 1 ... or C2 ... .

Resetting accessory to factory default, or selecting default actions on multi-sun, puts full sunrise and sunset events on

channel 22 regardless of simulator 'main' channel, so this setting must be made before changing main channel

actions.

Page 64 of 120

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 119 120

Sem comentários

Draper SC1 Manual de Instruções Página 64