Draper SC1 Manual de Instruções descarregar pdf (Página 46)

Input Device Sample Conﬁ guration

™ by Draper

Notes on Power Consumption:

Any input device may be connected to any available Eye port.

All Eye ports are "powered" by the "SC1" they feed off of. Each

SC1 Eye port provides 75 milliAmps at 5v of power to the connect-

ed input devices. You may attach any combination of input devices

to an SC1 Eye port, as long as the combined power requirements

do not exceed the available power from the SC1 (see chart below).

Notes on Cable Lengths:

You can have a total of approximately 100 feet of

cable between SC1s, up to a maximum of 1000 feet.

However, any device that includes a Repeater can

drive 1000 feet of cable regardless.

IR Eyes have no circuit board and can only drive

about 20' of cable.

Input Device Power Consumption Chart

Input Device

Power Consumption (milliAmps)

RF Remote Receiver 17

IR Receiver Eye 2

Sun Sensor 13

IntelliFlex Bus Switch 8

IntelliFlex RF Switch (not on Bus) 0

IntelliFlex Dry Contact Switch (not on Bus) 0

PSI60 9

R2D7 (RS232 Translator) 17

Hardwired Keypad 1

RF Keypad (not on Bus) 0

IR Eye can drive a maximum of 25 SC1s. Other accessories can drive a maximum of 70 SC1s.

Please Note:

Wiring diagrams are available for each control

and input device at www.draperinc.com.

Eye

Main

Aux

SC1,

SPGC4

or SGC4

SC1,

SPGC4

or SGC4

SC1,

SPGC4

or SGC4

Eye

Main

Aux

Sun

Sensor

To "Eye"

Port

(+75mA)

From "Aux"

To "Aux"

(can also

be "Aux to Eye")*

From "Aux"

To "Eye"*

To "Eye" Port

Eye

Main

Aux

R2D7

Receiving

Eye (-2 mA)

RR24 RF

Receiver

SC1,

SPGC4

or SGC4

From "Aux"

To "Aux"

(can also be

"Eye to Aux"

if "Eye" port

not in use)*

Eye

Main

Aux

To "Eye" Port

1 sample "Bus" System shown (motors on line voltage side). Multiple "Systems" may be combined and "linked" in an installation.

SC1,

SPGC4

or SGC4

PSI

SPDT:

Keyswitch,

Mag. switch,

etc.

Splitter

To Motor (s)

SC1,

SPGC4

or SGC4

From "Aux" To "Aux"

(can also be "Eye to Aux"

if Eye port is not in use)*

To Motor (s)

IntelliFlex Switch

(Local/Sub-group/

Master Control)

To "Eye" Port

PSSW

(+75mA)

(-17 mA)

(-13 mA)

(-8 mA)

(-9 mA)

From "Aux"

To "Eye"*

Sun

Sensor

Eye

*Never connect "Eye" port

to "Eye" port

PC/

Home

Automation

IR Signal

to Eye

RF Signal

to Receiver

IntelliFlex Switch

(Local/Sub-group/

Master Control)

(-8 mA)

Page 46 of 120

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 119 120

Comentários a estes Manuais

Sem comentários

Draper SC1 Manual de Instruções Página 46

Comentários a estes Manuais

Manuais e produtos relacionados com não Draper SC1